Treema

f* my build epoxy how should i strip it

Rate this topic

4 posts in this topic

Does anyone have any idea how i can fix my rod epoxy i f* it pretty good but i have one coat on the rod already should i just let the layer dry sand it slowly and then redo it?  

Share this post


Link to post
Share on other sites

How fresh is it? Day or two old comes off easy w/ a lil heat from an alcohol lamp.Cut it off the top of the foot and peel the rest back.Much easier w/ fresh than old epoxy.If it's a "soft" set  on the epoxy you may not even have to heat it.

Share this post


Link to post
Share on other sites

it's not the guide it's the embellishment that got ruined but I don't want to remove the whole thing. What happened is that my hair got stuck when I was bending down to measuring some epoxy. I got most of the stuff out but it's all tacky so I was thinking to let it dry a day and sand and alcohol it then redo.

Share this post


Link to post
Share on other sites

cut with a sharp blade as much as you can and reapply.  Should be fine.  I've had much better luck cutting it off rather than sanding, especially if it's not fully cured. 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.