jettyjmpr

You's rod guys

Rate this topic

21 posts in this topic

Posted (edited) · Report post

Should i cut off the excess shrink wrap that hangs 1/2 inch past the actual rod blank cap or is that material supposed to be like that...im thinking the shrink wrap just worked its way down over time and i can trim it....is that correct

Edited by jettyjmpr
I cant spell

Share this post


Link to post
Share on other sites
3 hours ago, jettyjmpr said:

Should i cut off the excess shrink wrap that hangs 1/2 inch past the actual rod blank cap or is that material supposed to be like that...im thinking the shrink wrap just worked its way down over time and i can trim it....is that correct

NO push it into the end of the rod.

Share this post


Link to post
Share on other sites

Don't trim it; build up level with masking tape.If it's not snug,build up evenly with tape till it fits.The $330 manufacturer cut it short where it wouldn't show to save a penny.If you "trim" it, you're likely to have fit'n'finish trouble.Just slide the butt cap over it.Any 2-part epoxy from the hardware store will suffice.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.