YakDawg

Removing Quantum Accurist 100PT side cover

Rate this topic

5 posts in this topic

Trying to remove the handle side cover of my Accurist and can't figure it out.  I removed the 2 side screws, handle and drag control but the cover won't budge.  Any trick to this?  

Share this post


Link to post
Share on other sites
3 hours ago, squidder 329 said:

 

Thanks for the video. I had used that procedure to try and remove the cover.  I guess my cover is just stuck I didnt want to force it thinking there might be some internal screw I was unaware of. I may have to wait until the repair shop reopens after this virus stuff calms down. Thanks again for the video clip.

Share this post


Link to post
Share on other sites

YakDawg , 

 

remove the cover opposite the handle side and look for 2 Phillips heads screws as guide posts for the level wind , there may also be a screw behind the spool that screws into the back of the handle side cover . 

Share this post


Link to post
Share on other sites
53 mins ago, Dave RI said:

YakDawg , 

 

remove the cover opposite the handle side and look for 2 Phillips heads screws as guide posts for the level wind , there may also be a screw behind the spool that screws into the back of the handle side cover . 

Will check that out. Thanks.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now

  • Recently Browsing   0 members

    No registered users viewing this page.