YAKnDIVE

wtb Robert Sorby lathe tools

8 posts in this topic

I have two Henry Taylor skew chisels 1" and 1/2" and a parting tool. As pictured, parting tool is size on the bottom. Gone to carbide and a duplicator  for what I do so these have not seen a lot of use. $60 PayPal shipped to your door for the lot.

Regards
Puck

post-22984-0-38143000-1453228995.jpg

post-22984-0-70722000-1453229204.jpg

Edited by speedwell

Share this post


Link to post
Share on other sites

I will PM you my PPal address and since you are taking both skews I will send you my Lee Valley Skew Grinding Jig worth about $30 and the instructions. Allows you to sharpen skews with a very slight radius in them so you don't dig in on the skew corners. Please send me a postal addy to send this too. Happy they found a home. have fun turning.

Best Regards

Puck

 

And Micodese that WAS hijacking, it is not allowed on this site and is a huge NONO!!! Do not do it again please.

Share this post


Link to post
Share on other sites

PPal rec'd and parcel shipped yesterday. I will PM you with the tracking number and other info. I use a 3/4" Henry Taylor roughing gouge to knock the corners off hardwood when I am making pepper mills (3" square blanks) and it works just fine. Good luck with your search.

Regards

Puck

Share this post


Link to post
Share on other sites

  • Recently Browsing   0 members

    No registered users viewing this page.