Sign in to follow this  
Followers 0
Simp

A few more that I finished

Rate this topic

9 posts in this topic

simp how are you doing your tail wraps......i use old screw drivers with the tip cut off and i put them in a vice and make the loop then i take a peir of circle plyers and bend the loop up to its in the middle of the tail, put the loop back on the screwdriver and finish...that way the loop don't face down....very nice looking plugs :D:D:D

Share this post


Link to post
Share on other sites

Place the wire through the plug. Then bend it to a 45 degree angle. Now start your wrap around the round shaft in the vise. Pull the loop tight and inspect to see that it is formed on both sides of center. put it back on the shaft and do the wraps.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.