Sign in to follow this  
Followers 0
Angryeel

Tip top install?

Rate this topic

2 posts in this topic

Hi Al, I am about the replace a tip top on an old rod. The replacement I have is a tiny bit larger than the rod tip; the tip is tiny bit over 9/64ths, the tip top I have is a 10. Is there something I could do to build up the blank before installing the new tip? A nine did not seem to want to fit on the blank, but the 10 has a bit of play in it. Any advice would be great. Hope you have had a chance to do some fishing this season. Thanks,

Angryeel

Did a little searching and found the answer. Thanks again

 

[This message has been edited by Angryeel (edited 05-07-2002).]

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.