Sign in to follow this  
Followers 0
Russ L

40HH stripper on ferrule

Rate this topic

2 posts in this topic

Hi Al,

For the 1363M-2 e-glass 11'6" 2-piece blank, upon test casting I got good performance when the 40HH stripper was about 40" from the seat. This placed the 40HH directly on the female ferrule of the tip section-leaving no guides on the butt section.

-Are there any problems with this setup?

-Do I need to lay down any additional wraps on the ferrule for strength for the 40HH stripper?

 

Thank you, Russ

Share this post


Link to post
Share on other sites

Russ,

 

Just make sure you first do an underwrap of size A thread and apply a thin coat of finish to the underwrap. Allow it to cure for at least 4 full days before wrapping on the guide. Also, make sure to taper grind and buff out the guide feet well to insure a smooth overwrap.

 

I do this all the time and you should be fine.

 

Al

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.