Sign in to follow this  
Followers 0
vinnyb

splining revisited

Rate this topic

2 posts in this topic

I'm in the process of trying to locate the spline on the upper section of my 2-piece flyrod blank. When I load the blank with one hand on the butt & the tip on a table, it settles into one spot just like it should. Then when I rotate the blank 180 degrees, it settles into another spot. These very discernable points are obviously the soft & hard spines. The trouble is, I can't discern which is which - both feel the same & seem to have the same resistance.

 

At this point, can I assume that choosing which spline (hard or soft) on which to place the guides is irrelevant, so long as they're placed on one or the other?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.