Sign in to follow this  
Followers 0
HanoverStriper

704 Bent?

Rate this topic

9 posts in this topic

I recently picked up this 704 from another site. It appears to be very bent. I assume this is not normal??? Is there any way to fix this or is it junk? Thanks!

525

525

525

Share this post


Link to post
Share on other sites

The only way to fix that is with a TON of heat, any less and it will snap, must be heated to the point that it's not too hard to bend back, anything less it will snap for sure. BTW, you must strip all the parts out B4 trying.

Share this post


Link to post
Share on other sites
View Poststraight to the guides.

 

Not a bad idea. I got this cheap enough as a project reel, so I'm going to experiment with it before I attempt to straighten it out. If all fails, it will at least be a good parts reel.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0

  • Recently Browsing   0 members

    No registered users viewing this page.