Jump to content

Storing boat on the trailer

Rate this topic


Jon B

Recommended Posts

in my garage on the cement floor. I don't think I have room to take the tires off and was wondering the preferred way. Should I lay plywood on the floor where the tires are going to be and on mild days take the trailer for a short ride to offset the affects of sitting in one place for so long? I would have liked to jack it up and store my tires in the basement.frown.gif

 

Can't have everything.

 

Thanks

 

Jon B

Link to comment
Share on other sites

I don't know if this is preferred but perhaps you could use a bottle jack or floor jack to raise the tires just off the ground and place a cement block or 4x4's under the trailer supports to keep the tires just off the ground. Seems simple enough, and will keep you from getting flat spots on the tires if you are storing for a long period of time. Just lower the trailer onto the blocks and remove the jacks.

Link to comment
Share on other sites

I jack up the rear of the trailer on each side (near the tires) and place cinder blocks & a piece of pressure treated wood under the trailer frame. The tires still barely touch the ground, but all of the weight is off of them. I started doing this after one of the tires went flat in the middle of the winter one yearmad.gif

Link to comment
Share on other sites

It depends on the trailer. If it is a single axle, I would be more inclined to block the frame and keep the load off of the tires. If it's a tandem axle, it is not necessary especially if it's in your garage and you will be monitoring it regularly. Don't wory about flat spots, they will straighten put when you tow the trailer and the tires warm up.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to register here in order to participate.

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...