Jump to content


Photo

2001 Dodge Dakota Key fob need help programming


  • Please log in to reply
1 reply to this topic

#1 Lbifisherman429

Lbifisherman429
  • 1,000 Post Club!

  • PipPipPipPipPip
  • 2,694 posts
  • Joined: Dec-10 2007

Posted May 12 2011 - 5:27 AM

I had to buy a second key fob and now i need to program it. The numbers on both match up so i was wondering if any of you had instructions for this or have done this
Truck: 2001 Dakota



#2 Jetty Junkie

Jetty Junkie
  • Senior Member

  • PipPipPip
  • 282 posts
  • Joined: Oct-17 2009

Posted May 13 2011 - 10:26 PM

1. Press LOCK button 5 times at 2 second intervals to resynchronize remote.

2. Insert key into the ignition switch. Turn ignition to the RUN position (as far as you can
go without cranking engine). Wait for ignition chimes to stop.

3. Using the working remote, press and hold the UNLOCK button on the remote for 4 to 10
seconds.

4. Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and then
press the PANIC button ( on the programmed remote ) for 1 second and release both
buttons. A chime will sound to indicate that the remote programming mode has been
entered ( allow 3 seconds for chime to sound ).

5. Within 30 seconds of the chime, press and release the LOCK and UNLOCK buttons
simultaneously then press and release just the UNLOCK button on the same remote.
A chime will sound indicating the remote has been programmed. Press and release
the LOCK and UNLOCK buttons simultaneously and then press the UNLOCK button on
each new remote you wish to program at this time. Locks will cylce afer each additional
remote is programmed.

6. Turn the ignition OFF and remove key.

7. Test Remotes.


now playing on a rockpile near you...